|
Fixed, TEST, Mon May 27 16:17:48 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-27 16:17:16.001351
MUGAST alpha run no pedestal supression
test run qfter restarting system. temp is still qround 15deg
Stop at 2019-05-27 16:50:50.508660
Stop comment: source was not in correct position
EDIT: there is no data for this run; the entry was create because the scaler storage was on.
Stop at 2019-05-27 19:09:53.235957
Stop comment: type your message here
Stop at 2019-05-27 19:31:47.881701
Stop comment: type your message here |
|
Fixed, TEST, Tue May 28 10:43:58 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-28 10:43:42.122755
MUGAST alpha run no pedestal supression
test run after restarting system. temp is still around 5deg
Stop at 2019-05-28 14:47:46.808600
Stop comment: type your message here
Stop at 2019-05-28 15:22:40.074144
Stop comment: type your message here
Stop at 2019-05-28 15:57:47.785333
Stop comment: type your message here
Stop at 2019-05-28 16:59:06.325170
Stop comment: type your message here
Stop at 2019-05-28 17:14:12.527918
Stop comment: type your message here
Stop at 2019-05-28 17:34:19.526635
Stop comment:
Stop at 2019-05-28 17:52:55.515837
Stop comment: type your message here
Stop at 2019-05-28 18:17:09.389775
Stop comment: type your message here |
|
Fixed, TEST, Tue May 28 11:08:10 2019, mugast, MUST2, Hardware, 3-alpha, MG3 is tripping
|
| MG3T is tripping, tryied to set max current to 20uA but it still trip around 30V. |
|
Fixed, TEST, Thu May 30 15:42:13 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-30 15:41:17.803744
MUGAST alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
Stop at 2019-05-30 15:49:50.743195
Stop comment: type your message here |
|
Fixed, TEST, Thu May 30 15:55:15 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-30 15:54:16.275808
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
Stop at 2019-05-30 15:57:43.637854
Stop comment: type your message here |
|
Fixed, TEST, Thu May 30 15:58:20 2019, OttoRun, RUN, General, 3-alpha, Run230
|
*************************
Run : 230
*************************
Start at 2019-05-30 15:57:54.390230
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-30 15:59:04.950841
Stop comment: type your message here
Stop at 2019-05-30 16:01:48.801380
Stop comment: |
|
Fixed, TEST, Thu May 30 16:04:09 2019, OttoRun, RUN, General, 3-alpha, Run230
|
*************************
Run : 230
*************************
Start at 2019-05-30 16:04:07.241232
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-30 16:06:21.092742
Stop comment: type your message here |
|
Fixed, TEST, Thu May 30 16:08:39 2019, OttoRun, RUN, General, 3-alpha, Run230
|
*************************
Run : 230
*************************
Start at 2019-05-30 16:08:37.332238
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-30 16:09:38.806154
Stop comment: type your message here |
Fixed, TEST, Thu May 30 16:10:18 2019, OttoRun, RUN, General, 3-alpha, Run230 
|
*************************
Run : 230
*************************
Start at 2019-05-30 16:09:44.953775
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
MG4T =95V
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-31 06:39:11.358615
Stop comment: type your message here |
|
Fixed, e786s, Fri May 31 09:53:14 2019, Marlène, GRIT, General, , Alpha source --> status of detectors
|
MG3T has been fixed by changing the X kapton.
I have removed aluminium foil on square detectors, the noise is slightly higher.
MG4T is not working properly : noisy on X but no signal on Y !! I see no triggers on the Y side. I tried to increase bias but it did increase noise. I checked in the last calibration of e744 it was working properly. Also I had to do pedestal realignement for this detector because everything was shifted.
MG7T seem to be slightly different than before. Strips X are hidden from the trigger because it became suddenly noisy. |
|
Fixed, e786s, Mon Jun 3 18:00:10 2019, Marlène, GRIT, General, , MUGAST detectors status --> MG4T
|
The problem of MG4T ha sbeen solved by changing the feedthrough.
The pulser on Y was not working and we were seeing no events (no ORD) because there was a problem with the bias of board. The issue is due to the feedthrough.
So now MG4T (HT &BT) are plugged in a free feedthrough (below MG1T) and I see pulser signals on Y.
The bias seems to apply normally on all detectors (in the dark).
The pulser is seen on each boards.
I have put back aluminium foil on square but I could not test it. |
|
Fixed, TEST, Tue Jun 11 18:59:36 2019, OttoRun, RUN, General, 3-alpha, Run231
|
*************************
Run : 231
*************************
Start at 2019-06-11 18:58:31.909158
MUGAST 3alpha run pedestal supression
temperature -1 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-11 21:40:22.107913
Stop comment: |
|
Fixed, TEST, Tue Jun 11 21:44:38 2019, OttoRun, RUN, General, 3-alpha, Run232
|
*************************
Run : 232
*************************
Start at 2019-06-11 21:44:02.397316
MUGAST 3alpha run pedestal supression
temperature -1 deg (trap) & -4.5 deg (must2) consigne 5 deg
with pedestal suppression
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-12 10:05:20.279209
Stop comment: type your message here |
|
Fixed, e786s, Wed Jun 12 17:59:01 2019, mugast, OTHER, Software, , Online Energy Calibration
|
| Updated Online Energy calibration for MUGAST, based on run_0231 data |
|
Fixed, TEST, Thu Jun 13 09:46:40 2019, OttoRun, RUN, General, 3-alpha, Run234
|
*************************
Run : 234
*************************
Start at 2019-06-13 09:45:49.383074
Discard run
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-13 09:47:06.006149
Stop comment: Discard this run |
|
Fixed, TEST, Thu Jun 13 09:47:39 2019, OttoRun, RUN, General, 3-alpha, Run235
|
*************************
Run : 235
*************************
Start at 2019-06-13 09:47:19.893278
Discard run
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-13 14:23:23.430392
Stop comment: type your message here |
|
Fixed, e786s, Wed Jun 19 10:09:10 2019, mugast, MUST2, Hardware, N/A, Time calibrator cabled
|
range 640 ns
period 20 ns |
|
Fixed, e786s, Wed Jun 19 12:02:07 2019, OttoTime, RUN, General, N/A, TimeCalibratorRun
|
*** Run Time Calibrator FSC ***
- Run: 237
- MUVI: MUVI1
- Side : MUFEE X (Junction)
- Telescope: 1, 2, 3, 4 |
|
Fixed, e786s, Wed Jun 19 12:24:43 2019, OttoTime, RUN, General, N/A, TimeCalibratorRun
|
*** Run Time Calibrator FSC ***
- Run: 238
- MUVI: MUVI1
- Side : MUFEE Y (Ohmic)
- Telescope: 1, 2, 3, 4 |
|
Fixed, e786s, Wed Jun 19 12:48:13 2019, OttoTime, RUN, General, N/A, TimeCalibratorRun
|
*** Run Time Calibrator FSC ***
- Run: 239 - MUVI: MUVI2
- Side : MUFEE X (Junction)
- Telescope: 1, 2, 3, 4 |
|