|
MUST2
SAMURAI_2018
S3-LEB-LPC
SUPERNEMO
MUGAST
EXPAND
SCALP
GALATRON
HiCARI
VELO
|
| MUST2 |
Not logged in |
|
|
|
|
Message ID: 445
Entry time: Thu May 24 05:44:56 2018
|
| Author: |
iulian |
| ExpNbr: |
e744 |
| Type: |
RUN |
| Category: |
General |
| Status: |
Pinned |
| Target-Source: |
N/A |
| Subject: |
Important::analysis of the run 443/ things to do |
|
|
No stop on t5, but TAC MM_CATS ok.. So two possibilities:
1) Stop Cable not connected on Muvi2
2) Problem with the validation of CATS by FAG
HF validated by FAG was not working
Dead time scaler was not working
We need to erase all the scalers at the beginning of the run, including the part from Muvi (ORD, DESC, etc). Atm we erase only the U2M not the other part
The big problem is the transmission between LISE silicon detector D6 and T5 must with CATS on or off. 3000 counts/s on silicon d6 or CATS -> maximum 300 on T5. Is there a way to miss counting in Must2?
TAC_CATS_HF ok
TAC_MM_CATS ok
T_MM_EXLor present with prompt from cosmics?!
T_MM_HF ok
T_MM_HFv not present |
|
|
|
|
|
|
|
|