|
Fixed, com2019, Mon Apr 1 10:19:35 2019, OttoRun, RUN, General, 3-alpha, Run162
|
*************************
Run : 162
*************************
Start at 2019-04-01 10:19:06.538659
Run Conditions:
- Operator: Adrien
- Trigger: MUGAST
- Target/Source: double face 3 alpha
- Beam: N/A
- Intensity:
Comment:
Stop at 2019-04-01 10:50:54.111644
Stop comment: DAS config seems strange |
|
Fixed, com2019, Mon Apr 1 11:00:04 2019, OttoRun, RUN, General, 3-alpha, Run163
|
*************************
Run : 163
*************************
Start at 2019-04-01 10:59:50.885757
Run Conditions:
- Operator: Adrien
- Trigger: MUGAST
- Target/Source: double face 3 alpha
- Beam: N/A
- Intensity:
Comment: restart run after running fsc config
Stop at 2019-04-01 14:54:39.130308
Stop comment: some warning in narval |
|
Fixed, com2019, Mon Apr 1 19:53:09 2019, OttoRun, RUN, General, 3-alpha, Run165
|
*************************
Run : 165
*************************
Start at 2019-04-01 19:52:02.219719
Run Conditions:
- Operator: Marlene
- Trigger: 3 first entries of GMT
- Target/Source: alpha
- Beam: N/A
- Intensity:
Comment: 3 alpha source calibration with all detectors
Stop at 2019-04-02 09:02:53.007743
Stop comment: |
|
Fixed, com2019, Tue Apr 2 08:52:16 2019, Freddy, MUST2, General, 3-alpha, PEDESTAL save - run 165
|
Normalized Pedestal value loaded in DAS for run 165 (3-alpha)
folder: /home/mugast/ganacq_manip/mugast/das-save/pedestal-save/run165
NB: Not sure when this pedestal values were read from the board, in principle should have been read just before the run. |
Fixed, com2019, Tue Apr 2 09:08:05 2019, OttoRun, RUN, General, 3-alpha, Run166 
|
*************************
Run : 166
*************************
Start at 2019-04-02 09:07:03.468248
Run Conditions:
- Operator: Freddy
- Trigger: 3 first entries of GMT
- Target/Source: alpha
- Beam: N/A
- Intensity:
Comment: 3 alpha source calibration with all detectors without pedestal subtraction to check their alignment
Stop at 2019-04-02 09:13:46.822878
Stop comment: |
|
Fixed, e744s, Thu Apr 18 09:28:12 2019, Marlène, MUST2, General, 3-alpha, RUN 206 (mugast) 3Alpha calib after e744s experiment
|
RUN 206
3 alpha source all detectors with no change in the configuration (low thresholds in MUST2)
From 17/04 18h13 -> 18/04 9h31 |
|
Fixed, TEST, Mon May 27 16:17:48 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-27 16:17:16.001351
MUGAST alpha run no pedestal supression
test run qfter restarting system. temp is still qround 15deg
Stop at 2019-05-27 16:50:50.508660
Stop comment: source was not in correct position
EDIT: there is no data for this run; the entry was create because the scaler storage was on.
Stop at 2019-05-27 19:09:53.235957
Stop comment: type your message here
Stop at 2019-05-27 19:31:47.881701
Stop comment: type your message here |
|
Fixed, TEST, Tue May 28 10:43:58 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-28 10:43:42.122755
MUGAST alpha run no pedestal supression
test run after restarting system. temp is still around 5deg
Stop at 2019-05-28 14:47:46.808600
Stop comment: type your message here
Stop at 2019-05-28 15:22:40.074144
Stop comment: type your message here
Stop at 2019-05-28 15:57:47.785333
Stop comment: type your message here
Stop at 2019-05-28 16:59:06.325170
Stop comment: type your message here
Stop at 2019-05-28 17:14:12.527918
Stop comment: type your message here
Stop at 2019-05-28 17:34:19.526635
Stop comment:
Stop at 2019-05-28 17:52:55.515837
Stop comment: type your message here
Stop at 2019-05-28 18:17:09.389775
Stop comment: type your message here |
|
Fixed, TEST, Tue May 28 11:08:10 2019, mugast, MUST2, Hardware, 3-alpha, MG3 is tripping
|
| MG3T is tripping, tryied to set max current to 20uA but it still trip around 30V. |
|
Fixed, TEST, Thu May 30 15:42:13 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-30 15:41:17.803744
MUGAST alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
Stop at 2019-05-30 15:49:50.743195
Stop comment: type your message here |
|
Fixed, TEST, Thu May 30 15:55:15 2019, OttoRun, RUN, General, 3-alpha, Run229
|
*************************
Run : 229
*************************
Start at 2019-05-30 15:54:16.275808
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
Stop at 2019-05-30 15:57:43.637854
Stop comment: type your message here |
|
Fixed, TEST, Thu May 30 15:58:20 2019, OttoRun, RUN, General, 3-alpha, Run230
|
*************************
Run : 230
*************************
Start at 2019-05-30 15:57:54.390230
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-30 15:59:04.950841
Stop comment: type your message here
Stop at 2019-05-30 16:01:48.801380
Stop comment: |
|
Fixed, TEST, Thu May 30 16:04:09 2019, OttoRun, RUN, General, 3-alpha, Run230
|
*************************
Run : 230
*************************
Start at 2019-05-30 16:04:07.241232
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-30 16:06:21.092742
Stop comment: type your message here |
|
Fixed, TEST, Thu May 30 16:08:39 2019, OttoRun, RUN, General, 3-alpha, Run230
|
*************************
Run : 230
*************************
Start at 2019-05-30 16:08:37.332238
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
Unsual bias for MG4T =130V, I=4 uA because no trigger on Y.
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-30 16:09:38.806154
Stop comment: type your message here |
|
Fixed, TEST, Thu May 30 16:10:18 2019, OttoRun, RUN, General, 3-alpha, Run230
|
*************************
Run : 230
*************************
Start at 2019-05-30 16:09:44.953775
MUGAST 3alpha run pedestal supression
temperature -3 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
MG4T =95V
same as before except that MG7 had a mate hidden on Y (now it is on)
Stop at 2019-05-31 06:39:11.358615
Stop comment: type your message here |
|
Fixed, TEST, Tue Jun 11 18:59:36 2019, OttoRun, RUN, General, 3-alpha, Run231
|
*************************
Run : 231
*************************
Start at 2019-06-11 18:58:31.909158
MUGAST 3alpha run pedestal supression
temperature -1 deg (trap) & -4 deg (must2) consigne 5 deg
no pedestal suppression (but alignement)
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-11 21:40:22.107913
Stop comment: |
|
Fixed, TEST, Tue Jun 11 21:44:38 2019, OttoRun, RUN, General, 3-alpha, Run232
|
*************************
Run : 232
*************************
Start at 2019-06-11 21:44:02.397316
MUGAST 3alpha run pedestal supression
temperature -1 deg (trap) & -4.5 deg (must2) consigne 5 deg
with pedestal suppression
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-12 10:05:20.279209
Stop comment: type your message here |
|
Fixed, TEST, Wed Jun 12 18:40:57 2019, OttoRun, RUN, General, 3-alpha, Run233
|
*************************
Run : 233
*************************
Start at 2019-06-12 18:40:34.500264
MUGAST 3alpha run pedestal supression
temperature -1 deg (trap) & -4.5 deg (must2) consigne 5 deg
without pedestal suppression
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-13 09:06:36.277090
Stop comment: |
|
Fixed, TEST, Thu Jun 13 09:46:40 2019, OttoRun, RUN, General, 3-alpha, Run234
|
*************************
Run : 234
*************************
Start at 2019-06-13 09:45:49.383074
Discard run
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-13 09:47:06.006149
Stop comment: Discard this run |
|
Fixed, TEST, Thu Jun 13 09:47:39 2019, OttoRun, RUN, General, 3-alpha, Run235
|
*************************
Run : 235
*************************
Start at 2019-06-13 09:47:19.893278
Discard run
alpha source in front of cryogenic target, NOT AT TARGET POSITION !!!
Stop at 2019-06-13 14:23:23.430392
Stop comment: type your message here |
|